DSP之看门狗不断进行复位（It appears that the target is being held in reset）_it appears that the target is being held in reset.

作者：盐析白兔 | 2024-06-13 14:13:20

踩

it appears that the target is being held in reset. this may be due to wait-i

问题描述：It appears that the target is being held in reset. This may be
due to Wait-In-Reset (WIR) configuration set by the EMU0=0
and EMU1=1 pin settings. If this is the case, DISCONNECT
all CONNECTED devices including icepick and then select
RETRY to clear the WIR configuration.

解决方法：看门狗不断进行复位，将其与硬件复位端口断开连接

声明：本文内容由网友自发贡献，不代表【wpsshop博客】立场，版权归原作者所有，本站不承担相应法律责任。如您发现有侵权的内容，请联系我们。转载请注明出处：https://www.wpsshop.cn/w/盐析白兔/article/detail/713225